2016 JEEP RENEGADE SPORT 4X2

The vehicle is listed with a salvage vehicle title, and the auction identifies the primary damage as “REAR END.” Stage 1 reports that the visible rear-end damage—including the missing rear bumper assembly, missing tail lamp, deformed rear quarter panels, and creased liftgate—supports the auction’s unverified primary-damage claim. The salvage-title status cannot be confirmed from the available photos. The rear bumper cover and associated lower rear fascia components are missing, exposing internal brackets, wiring, and underbody components. The right rear tail lamp assembly is also absent, leaving its wiring and mounting areas exposed. The liftgate has a horizontal crease and inward denting below the Jeep emblem and around the license-plate mounting area. Both the left and right rear quarter panels and wheel-arch areas show severe deformation, creasing, displaced panel sections, separated exterior edges, and exposed inner components. Additional bending and creasing are visible in the lower rear body and mounting structure. The front left and right wheel-arch flares are missing. The rear wheel-arch flares are also absent on both sides, exposing mounting fasteners and the underlying wheel-arch edges. A reported NHTSA recall applies to certain 2015–2016 Jeep Renegade vehicles equipped with the factory-installed optional trailer hitch package. The hitch may have been installed with insufficient fasteners, allowing it to separate from the vehicle; the remedy was installation of additional fasteners. A separate recall applies to certain aftermarket Daystar rear control-arm brackets included in a 1.5-inch spacer kit, where improper welds could allow rear-axle movement. Vehicle equipment and recall completion should be verified by VIN and physical inspection.