2016 JEEP COMPASS LATITUDE FWD

The auction record identifies this 2016 Jeep Compass as having a salvage vehicle title, with SIDE listed as the primary damage. The supplied visual assessment reports substantial deformation and scraping on both sides of the vehicle, supporting the SIDE damage classification; however, salvage-title status cannot be confirmed from photographs. The exterior has extensive collision damage. On the near side, the front fender is crushed and creased around the wheel opening and behind the headlamp, with portions of the adjacent black wheel-arch trim appearing to be missing. The front door and lower side panels have broad dents, horizontal creases, scraped paint, and discoloration. The front bumper also has surface scuffing and scratches. The opposite side shows more severe deformation. The rear door and rear quarter panel have large inward dents, sharp creases, and extensive paint scraping. Additional denting is visible on the front door, while the rocker panel and lower side trim are deformed and scraped. The overall condition indicates that multiple doors, side panels, rocker-area components, and exterior trim may require repair or replacement. Mechanical, structural, suspension, wheel, and alignment condition cannot be determined from the provided findings. The interior shows moderate upholstery wear. The front seats and center armrest have cracking, peeling, discoloration, and worn-through areas. The rear seats have scuffing, discoloration, peeling, and other worn patches, particularly along the lower cushion edge. The infotainment surround and passenger-side dashboard trim have multiple scratches and white abrasion marks. According to the VIN decode, this is a U.S.-built 2016 Jeep Compass Latitude SUV with front-wheel drive, a 2.0-liter four-cylinder gasoline engine, and a four-door body. The vehicle was manufactured by FCA US LLC at the Belvidere Assembly plant in Illinois. One NHTSA recall is listed for certain 2016 Jeep Compass vehicles manufactured from May 9, 2016, through July 15, 2016. The recall concerns intermittent operation of the crankshaft or camshaft sensor, which may cause the engine to stall and increase crash risk. The stated remedy is replacement of the sensor connector by an authorized dealer, free of charge. The vehicle’s manufacturing date and recall completion status are not provided, so recall applicability and completion should be confirmed by VIN with Jeep or an authorized dealer.