2026 BMW X6 xDrive40i

The vehicle is listed by the auction with a Certificate of Salvage and a damage designation of more than 75%, with “FRONT END” identified as the primary damage. Stage 1 reports that the visible front-end damage supports the auction’s primary-damage claim; however, the photographs do not establish whether the total damage exceeds 75%. The front-left area has severe collision damage. The hood is heavily creased and deformed across its front-left section, including a raised, uneven edge above the headlamp and grille. The front bumper cover is fractured and partially missing on the left side and lower center, with broken lower sections, scraping, and internal components exposed. Outer bumper sections around the front-left corner and wheel-arch area are absent, and the headlamp area contains exposed or broken components with surrounding trim and portions of the outer assembly missing. The driver airbag is deployed from the steering wheel. Curtain airbags are also deployed along the roof side and windshield area, including above the rear passenger compartment. The extent of the restraint-system deployment indicates that the airbag system and related safety components will require comprehensive inspection and likely replacement as part of the repair. According to the VIN decode, this is a 2026 BMW X6 xDrive40i sport utility vehicle with all-wheel drive, a 3.0-liter gasoline six-cylinder engine rated at 375 horsepower, and a U.S. manufacturing location in Greer, South Carolina. Two NHTSA recalls are listed for certain 2026 BMW X6 vehicles. Recall 25V671000 concerns an improperly sealed windshield that may allow water to reach electrical components, potentially causing loss of headlights or door-closing functions or an electrical short. The stated remedy is windshield inspection and resealing, with replacement of the vehicle control unit and wiring if required. Recall 25V837000 concerns instrument-panel manufacturing that could prevent the passenger-side airbag from deploying properly; the stated remedy is replacement of the instrument-panel trim. The applicability and completion status of these recalls should be confirmed by VIN with BMW or an authorized dealer.