2013 BMW X1 xDrive28i

This 2013 BMW X1 xDrive28i is listed with a CERTIFICATE OF TITLE status and FRONT END as the auction’s primary-damage code. The visible damage supports the unverified FRONT END classification. However, the CERTIFICATE OF TITLE status cannot be verified from the photographs. The vehicle has severe damage concentrated at the front corner. The front bumper cover is cracked, torn, partially detached, and missing sections, with internal components exposed. The front grille and surrounding bumper plastics are also broken or missing. A lower front fascia section is hanging beneath the vehicle, and detached exterior plastic pieces are visible on the floor. The headlamp assembly at the damaged corner appears broken or absent, with exposed mounting areas and internal components. The adjacent fender and wheel-arch area are severely deformed, with torn and separated panel sections. The hood has several pronounced creases and moderate deformation near the affected front corner and front edge. The opposite headlamp lens shows yellowed or cloudy discoloration. The instrument cluster was illuminated and displayed warning indicators, including seat-belt and washer-fluid symbols. The available image does not establish a mechanical or electrical failure. The extent of the visible front-end damage means that the condition of the underlying structural components, cooling system, suspension, steering, safety systems, wiring, and engine-bay components requires physical inspection and testing. According to the VIN decode, this is a Germany-built BMW X1 Sport Utility Vehicle with all-wheel drive, a 2.0-liter four-cylinder gasoline engine, and the xDrive28i trim. The decoded vehicle information lists a 2013 model year and an engine output of 241 horsepower. Two NHTSA safety recalls are listed for this model and configuration: recall 20V017000 concerns the driver frontal air-bag inflator, and recall 24V608000 concerns the electric water-pump connector and protective shield due to a potential short-circuit and fire risk. Recall completion should be confirmed by the VIN with BMW or an authorized dealer before purchase.