2014 BMW X1 xDrive28i

This 2014 BMW X1 is listed with an auction primary-damage classification of “FRONT END” and an auction condition of “PERMIT TO SELL.” Stage 1 reports that the visible front-end damage supports the unverified FRONT END classification, while the photos do not independently confirm the PERMIT TO SELL condition. The vehicle has severe damage across the front end. The hood is buckled and raised along the front edge, with substantial distortion, an uneven contour, and large gaps above the grille and headlamps. The front bumper cover is severely cracked, torn, and displaced at both front corners, with open gaps and exposed components behind the fascia. The painted grille surround is moderately cracked and deformed, with separated edges and gaps around the kidney grilles. The lower black bumper trim and grille area are also displaced, with uneven edges and an irregular opening. Open and irregular areas are visible along the front edge of the engine compartment behind the damaged fascia. The extent of any damage to structural components, cooling-system parts, lighting, safety systems, or other components behind the front fascia cannot be determined from these findings alone. A thorough physical inspection and diagnostic scan are recommended before purchase, along with verification that all required repairs have been completed correctly. According to the VIN decode, this is a BMW X1 xDrive28i Sport Utility Vehicle with all-wheel drive, a 2.0-liter four-cylinder gasoline engine, and the xDrive28i trim. The vehicle was manufactured by BMW AG in Leipzig, Germany. Two NHTSA safety recalls are listed for this vehicle configuration. Recall 20V017000 concerns the driver frontal air-bag inflator, which may rupture and project metal fragments; the remedy is replacement of the driver air bag. Recall 24V608000 concerns the engine water-pump electrical connector, which may short circuit and increase the risk of fire; the remedy involves inspection or replacement of the water pump and connector, together with installation of a protective shield as necessary. Recall completion should be verified with BMW or an authorized dealer using the vehicle identification number.