2014 BMW X1 XDRIVE28I

The auction lists the primary damage as Front End. Stage 1 reports that the visible evidence supports this classification, with substantial damage to the hood, front bumper, grille area, headlamps, and adjacent front body panels. The hood is severely deformed across its front edge and both corners, with an uneven raised gap above the grille and headlamps. The right headlamp lens and internal lens area are cracked and fractured. The left headlamp assembly is separated from the surrounding body panels, with exposed gaps along its upper and inner edges. The kidney grille surround and adjacent upper front trim are displaced, with uneven gaps from the hood and bumper. The front bumper cover is separated at the upper corners and has irregular gaps, a visible vertical crack or split near the lower center, and additional surface marks. The left front fender edge is separated near the headlamp and bumper interfaces. These findings indicate that the front-end repair may involve multiple exterior components and mounting points; the condition of structural components, cooling-system parts, lighting functionality, and safety systems requires physical inspection. Additional damage is visible on the left front door, including a broad moderate dent across the middle and lower outer panel and minor vertical discoloration and paint scuffing around and below the handle. VIN decoding identifies this vehicle as a 2014 BMW X1 xDrive28i, an all-wheel-drive SUV with a 2.0-liter, four-cylinder gasoline engine. The vehicle was manufactured by BMW AG in Germany. Two NHTSA recalls are listed for this vehicle configuration. Recall 20V017000 concerns the driver frontal air-bag inflator and the risk of inflator rupture; the stated remedy is replacement of the driver air bag. Recall 24V608000 concerns the engine water-pump electrical connector, which may short circuit and increase the risk of fire; the stated remedy is inspection and replacement of the water pump and connector as necessary, together with installation of a protective shield. Recall repair completion should be verified before purchase.