2021 BMW M340I M340I XDRIVE

The 2021 BMW M340i, VIN 3MW5U9J0XM8B60666, has extensive collision damage concentrated on the vehicle’s left side. Both the left front and left rear doors are severely crushed, with deep dents, sharp creases, folds, paint abrasion, exposed dark areas, damaged lower edges, and deformation around the handles and door seams. The front-door opening line is irregular, and the rear door panel is visibly folded inward. The rocker-panel or side-sill area below the left-side doors has moderate visible folding and deformation. A white curtain airbag is deployed and hanging from the left roofline and side-window area above the front seating position. The available findings do not document the condition of the suspension, wheel alignment, inner door structures, B-pillars, floor, or other mechanical and safety systems. A thorough structural, restraint-system, and mechanical inspection is recommended before purchase or repair. The auction records identify the vehicle’s condition as “Clear” and list “Right Side” as the primary damage. However, Stage 1 reports that the visible evidence contradicts both claims: extensive collision damage is present on the left side, involving both left-side doors and the lower rocker-panel area, together with a deployed left-side curtain airbag. These auction classifications should therefore be treated as unverified claims rather than established descriptions of the vehicle’s actual condition. Factory/NHTSA VIN data identifies this vehicle as a four-door BMW M340i sedan with all-wheel drive, a 2.997-liter six-cylinder gasoline engine rated at 382 horsepower, and an eight-speed automatic transmission. The vehicle was manufactured in Mexico. NHTSA records list several recalls applicable to the 2021 BMW M340i or M340i xDrive. Campaign 20V761000 concerns a possible improperly assembled connection between the 48-volt battery and starter-generator, which may increase fire risk; the remedy is inspection and replacement if necessary. Campaign 21V096000 concerns rearview-camera image or software problems and requires inspection and a software update if needed. Campaign 21V298000 concerns a front seat-belt buckle assembly bolt that may not have been tightened correctly. Campaign 21V554000 concerns passenger-seat-belt automatic-locking retractors that may deactivate prematurely. Campaign 23V211000 concerns improperly welded seat frames, and campaign 23V584000 concerns software that may fail to provide the required audible seat-belt warning. Recall completion should be verified with BMW or an authorized dealer, particularly because the vehicle has a deployed curtain airbag and visible collision damage.