2024 BMW 530I

The vehicle is a 2024 BMW 530i sedan, VIN WBA43FJ07RCR24518. NHTSA data identifies it as a gasoline-powered model with a 2.0-liter four-cylinder engine, manufactured by BMW AG in Dingolfing, Germany. The drivetrain and transmission details were not provided. The auction designation is Salvage, with Front End listed as the primary damage. Stage 1 reports that the visible evidence supports the Front End classification: severe damage and missing components are concentrated at the front of the vehicle. The front end has extensive collision damage. The hood is severely crushed and folded across the center and both front corners, with deep creasing, raised sections above the fenders, chipped and peeling paint, and two large irregular openings with torn metal edges. Both headlamp assemblies are removed from the vehicle, leaving open cavities and exposed components. The detached assemblies show visible surface or housing damage, including cracking, deformation, and damaged mounting areas. The painted front bumper cover, grille, headlamp surrounds, and multiple front fascia and trim pieces are missing. The bumper reinforcement, cooling assemblies, brackets, mounting points, lower grille area, wiring, and other internal components are exposed. Lower black front trim is detached and hanging below the front structure. Several electrical connectors and wiring sections are exposed or hanging around the bumper and headlamp areas. The supplied findings document substantial exterior front-end damage, but they do not establish the condition of concealed structural, cooling, electrical, restraint, or mechanical components. A comprehensive physical inspection and post-repair diagnostic scan would be required. The rear bumper has light horizontal scuffs and minor surface scratches, particularly on the left side. No other damage findings were provided. The supplied NHTSA recall data includes campaigns concerning this model range. Recall 23V700000 concerns an incorrectly attached steering-wheel ground connection that may disable the hands-on detection system; the remedy is inspection and reattachment as necessary. Recalls 24V104000, 24V697000, and 24V739000 concern possible integrated brake-system, power-brake-assist, ABS, or Dynamic Stability Control malfunctions, with replacement of the integrated brake system or module as the applicable remedy. Recall 26V056000 concerns possible starter overheating and fire risk on certain 2021–2024 5 Series xDrive vehicles; applicability depends on the vehicle’s drivetrain and VIN. The provided data also lists campaign 26V422000 for certain 2025 5 Series vehicles, so its applicability to this 2024 vehicle should be confirmed directly by VIN. Recall completion and any outstanding campaign status should be verified with BMW or NHTSA before purchase.