2020 BMW 430I

The vehicle is a 2020 BMW 430i convertible with a 2.0-liter turbocharged four-cylinder gasoline engine, eight-speed automatic transmission, and rear-wheel drive information not specified in the available VIN data. It was manufactured by BMW AG in Germany. The auction lists the vehicle as salvage, with “Right Rear” recorded as the primary damage. The right-rear damage classification is supported by the visible rear bumper crushing, tearing, and separation. However, the salvage status cannot be confirmed from exterior photographs alone. The rear bumper cover is severely crushed and heavily deformed across the center and both corners, with deep creases, extensive scraping, and abrasion. The right rear corner has a large torn opening with missing material and exposed internal areas. A wide, uneven gap is visible where the bumper meets the body below the right tail lamp. The lower edge of the trunk lid is bowed and uneven, creating an irregular gap above the bumper. The available findings do not confirm the condition of the underlying body structure, rear impact components, lighting, sensors, trunk operation, or mechanical systems; these areas should be inspected before purchase. An NHTSA-listed recall applies to certain 2020 BMW 430i vehicles concerning improperly folded or assembled driver and passenger knee air-bag modules. The stated consequence is that an air bag may not deploy as intended. BMW’s listed remedy is replacement of the knee air-bag modules at no charge through authorized dealers. Recall completion should be verified by VIN with BMW or an authorized dealer.