2013 BMW 335 xDrive

The auction record identifies this vehicle as having a salvage title with “REAR END” listed as the primary damage. Stage 1 reports that the visible extensive rear-end deformation, missing rear bumper cover, missing rear lamps, and crushed trunk lid support the stated rear-end primary-damage claim. The salvage-title status itself cannot be confirmed from the photos alone. The vehicle has severe collision damage concentrated throughout the rear structure. The trunk lid is heavily crushed and deformed, and in some views it is detached or missing, leaving the trunk opening fully exposed. Both rear quarter panels and the surrounding trunk-opening edges show extensive crushing, sharp creases, torn edges, displaced metal, and irregular panel surfaces. The rear body panel and both rear corners are also visibly deformed. The rear bumper cover is absent from the vehicle, exposing the bumper reinforcement, mounting structures, inner panels, wiring, and other internal components. Both rear lamp assemblies are missing from their mounting positions, with empty cavities and exposed electrical wiring. Some of the rear wiring and components are hanging below the body. The detached trunk lid and rear bumper cover are shown separately, along with two detached rear lamp assemblies. The left rear quarter panel also has scrapes and areas of missing or abraded red paint over the damaged metal. Based on the supplied findings, substantial rear-body repair or replacement will be required. The condition of the underlying frame or unibody structure, suspension, drivetrain, electrical systems, airbags, and other mechanical components is not established by these findings and requires a thorough physical inspection. VIN data identifies the vehicle as a 2013 BMW 335i xDrive sedan, manufactured by BMW AG in Germany. It is listed with all-wheel drive, a 3.0-liter six-cylinder gasoline engine rated at 300 horsepower, direct TPMS, and driver, passenger, side, curtain, and knee airbags. One NHTSA safety recall is listed for this vehicle configuration: campaign 16V071000, concerning the driver frontal air-bag inflator, which may rupture during deployment and project metal fragments. The stated remedy is replacement of the driver’s frontal air-bag module or inflator by an authorized dealer at no charge. Recall completion should be verified using the vehicle identification number and BMW service records.