2016 BMW 328I

The 2016 BMW 328i is listed with an unverified auction condition of “Salvage” and a primary-damage code of “Front End.” Stage 1 reports that the visible extensive front-end collision damage supports the auction’s “Front End” code; however, the salvage status cannot be confirmed from photographs alone. The vehicle has severe damage across the front end. The hood is heavily bent, with sharp folds, raised and folded front sections, substantial creasing, and large gaps around the edges. The front bumper cover is missing from the vehicle and is shown separately with crushed and torn areas, broken openings, detached trim, and extensive deformation. The front grille inserts are also absent or detached. The viewer-right headlamp assembly is severely damaged, with broken and displaced outer and internal components, open gaps, and damage around its mounting area. The exposed front bumper reinforcement is visibly bent and deformed, particularly through the center and viewer-right section. The lower front trim and grille components are cracked, displaced, and hanging from the front fascia. The leading portion of the viewer-right front fender is folded and deformed around the headlamp and bumper area. With the front fascia removed, the radiator area, support components, wiring, and mounting points are exposed. The available findings do not establish the condition of the engine, cooling system, chassis alignment, suspension, steering, airbags, or other components behind the visible damage. A comprehensive physical inspection and structural assessment are recommended before purchase, along with verification of all required replacement parts and repair costs. Factory data identifies this vehicle as a BMW 328i sedan manufactured by BMW AG in Munich, Germany. It has a 2.0-liter, four-cylinder gasoline engine; the decoded data lists 241 horsepower. One NHTSA safety recall is recorded for the applicable 2016 BMW 328i model range, involving the electrical connector for the engine cooling water pump. The connector may be exposed to water and short circuit, increasing the risk of fire. BMW’s stated remedy is inspection and replacement of the water pump and connector as necessary, together with installation of a protective shield. Recall completion should be verified by VIN with BMW or an authorized dealer.