2013 PORSCHE PANAMERA Base (2WD), 4 (4WD)

This 2013 Porsche Panamera is listed with a salvage certificate of title, and the auction’s primary-damage classification is FRONT END. Stage 1 reports that the visible evidence supports this classification: the front bumper fascia and both headlamp assemblies are missing, with additional front-end deformation and detached components. The salvage-certificate status itself could not be confirmed from exterior photographs. The front bumper cover and surrounding fascia are absent, exposing the bumper reinforcement, radiator area, wiring, and internal mounting components. Both front headlamp assemblies are missing, leaving empty cavities and visible mounting structures on both sides. Plastic fascia, ducting, and mounting pieces at the left and right bumper corners are separated and hanging below the hood line. The leading edge of the hood has an irregular bent or creased contour, and the front-left bumper-side trim and adjacent wheel-arch plastic are missing or separated. The vehicle decodes as a 2013 Porsche Panamera sedan, manufactured by Dr. Ing. h.c.F. Porsche AG in Leipzig, Germany. It is identified with a 3.6-liter gasoline six-cylinder engine and a listed output of 300 horsepower. The decoded trim information indicates either the Base (2WD) or 4 (4WD) configuration; the supplied data does not establish which applies to this vehicle. Before purchase or road use, the exposed front structure, wiring, radiator area, mounting points, lighting system, hood alignment, and any related safety systems should be inspected in person. Replacement of the missing bumper, headlamps, trim, and detached components will be required, with the full extent of repair work to be determined through physical inspection. NHTSA records list three recalls for the 2013 Panamera: a gear-selector cable bushing that may detach and prevent the transmission from actually being in Park, possible water entry into the A/C blower control unit that may cause an electrical short and fire risk, and missing low-beam headlight adjustment-screw caps that may result in improper headlight aim. Recall completion should be verified by VIN with Porsche or an authorized dealer.