2022 MERCEDES-BENZ CLA 250 4MATIC

The auction lists the primary damage as “Front End.” This is an auction classification, while the visible-evidence assessment supports the claim: the front bumper components are detached and broken, the passenger-side headlamp mounting area is exposed, and the lower grille trim is detached. Substantial rear bumper damage is also visible. At the front, the passenger-side bumper cover is separated from the body, leaving a wide gap between the bumper, fender, and headlamp. The fascia surrounding the passenger-side headlamp is broken or missing, with dark mounting or structural material exposed. Lower bumper trim and grille sections are missing or detached, and one grille/bumper section is lying separately on the ground. The lower front opening exposes internal components. The condition indicates significant collision damage to the front bumper assembly; the images do not establish the condition of components behind it. The rear bumper is extensively crushed and deformed across the center and passenger-side areas. It has cracked and torn lower edges, missing lower trim, a distorted license-plate mounting area, and multiple scuff marks. The passenger-side lower edge is separated, with exposed material, and a small component or cable is hanging beneath the bumper. Further inspection is required to determine whether any underlying mounting, structural, sensor, lighting, or exhaust-related components were affected. VIN decoding identifies this vehicle as a 2022 Mercedes-Benz CLA-Class sedan, equipped with a 2.0-liter turbocharged four-cylinder gasoline engine, a seven-speed automatic transmission, and the M260 engine. The vehicle was manufactured by Mercedes-Benz Cars in Hungary. The decoded trim is listed as CLA250-4M; the supplied data does not provide a confirmed drivetrain description. A physical inspection and diagnostic scan are recommended before purchase, including checks of the bumper reinforcements and mounting points, headlamp assembly, parking or driver-assistance sensors, wiring, cooling components, rear impact components, and wheel alignment.