2020 AUDI A6

The auction record lists the vehicle as Salvage with Front End as the primary damage classification. Stage 1 reports that the visible damage at the front-left corner supports the stated Front End classification; however, the Salvage title or condition cannot be verified from photographs alone. The documented damage is concentrated at the front-left corner. The fender is severely creased and deformed above and behind the wheel opening, with an uneven edge near the headlamp and bumper. The front-left bumper cover is severely cracked and broken, with its lower corner separated and internal components exposed. Grille or trim pieces are missing from the lower bumper opening. The front-left headlamp lens has a jagged fracture or broken area in its lower inner section. Several light surface scratches or paint marks are also reported on the hood. The full extent of any damage behind the visible body panels, including possible effects on mounting points, sensors, lighting components, cooling components, steering, suspension, or the vehicle structure, is not established by these findings. A thorough physical inspection and diagnostic scan should be completed before purchase or repair. The VIN decodes as a 2020 Audi A6 quattro Premium sedan, built in Germany. It is equipped with all-wheel drive, a gasoline 2.0-liter turbocharged four-cylinder engine, and a seven-speed automatic transmission. NHTSA recall data provided for this model and year includes campaigns concerning the starter generator and possible electrical short circuit, passenger air-bag deployment and manufacturing issues, rear-axle lock nuts and alignment, fuel-level sender accuracy, liquid protection for the gateway control module, and rearview-camera software. Recall campaign 22V034000 also concerns rear-axle alignment and tire wear following earlier repairs. The supplied data does not confirm whether any applicable recalls have been completed, so the VIN should be checked with Audi or an authorized dealer before purchase.