2017 AUDI A4 quattro Premium Plus

The auction record identifies this 2017 Audi A4 as having a salvage title, with “FRONT END” listed as the primary damage. The photo-review verdict states that the visible damage supports the front-end classification, based on the missing and damaged bumper and fascia components; the salvage-title status cannot be confirmed from photos. The front bumper cover is completely missing, exposing the bumper reinforcement, cooling components, wiring, and other internal parts. The exposed metal bumper reinforcement is visibly crushed and irregularly deformed on the right side. The lower front grille and surrounding fascia are also absent, leaving the intercooler and other internal components exposed. Right-side corner trim and adjacent fascia are missing, with open mounting areas visible. Wiring and other components are loose and hanging below the front bumper area. A light surface scuff is visible on the lower rear bumper corner on the left side of the image. No other findings were provided. The VIN decodes as a 2017 Audi A4 sedan with quattro all-wheel drive, a 2.0-liter four-cylinder gasoline engine rated at 252 hp, and an automatic transmission. The vehicle is identified as the Premium Plus trim and was manufactured by Audi AG in Germany. One NHTSA safety recall is listed for this vehicle range: recall 21V874000 concerns a possible contact fault in the cable connecting the seat heater to the Passenger Occupant Detection System. This fault may cause the system to misdiagnose a malfunction and disable the front passenger airbag. The stated remedy is replacement of the connecting cable and either the heating mat or the complete seat cover, free of charge through an Audi dealer. Recall completion should be verified by VIN with Audi. Because the front bumper, reinforcement, grille, fascia, wiring, and cooling components are exposed or damaged, a thorough physical inspection is recommended before purchase. This should include checking for hidden structural or cooling-system damage, proper wiring and component mounting, operation of the restraint and airbag systems, alignment, and completion of all required repairs and recall work.